TY  - BOOK
AU  - Talha, Muhammad 
AU  - Supervisor : Dr. Adnan Munir
TI  - Thermo-Mechanical Analysis of High-Strength High-Temperature Glass Fiber Reinforced 3D Printed Composites
U1  - 621 
PY  - 2024///
CY  - Islamabad : 
PB  - SMME- NUST; 
KW  - MS Mechanical Engineering
N1  - 3D printing has revolutionized the way products are designed and manufactured. Composite
materials are considered the materials of the future because of their excellent material and
mechanical properties and excellent strength-to-weight ratio. Composite 3D printing combines the
best of both worlds. 3D-printed composite parts have excellent Mechanical and Material properties
and design freedom at the same time. On the contrary, composite 3D printing is fairly a new
technology and it is still under development. Research is being carried out; new materials are being
developed to take the full potential of composite 3D printing. As we know Composite Materials
are a replacement for our traditional metals, as they provide the same if not better performance and
are lightweight at the same time. A research gap still exists, considering the performance of 3Dprinted composite parts at elevated temperatures. This research focuses on Thermo-Mechanical
Analysis of High-Strength High-Temperature glass-fiber reinforced 3D printing
composites. Markforged Onyx served as the polymer matrix base and High-Strength HighTemperature Fiberglass was used as the fiber reinforcement for our composite design. This
research explores the influence of High-Strength High-Temperature fiberglass (HSHT FG) volume
fraction (Vf) and the temperature on the performance of composite test specimens, The 3-point
bending test is carried out following ASTM D-790 standard at 40℃, 60℃, and 80℃. Ansys
Composite PrepPost is used to model the composite laminates and Ansys Workbench is used for
simulations. Both the experimental and simulation results indicate an increase in Flexural Strength
and stiffness with the increase in HSHT FG volume fraction and a decrease in both with the
increase in temperature. The results also indicate that the increase in HSHT Fiberglass volume
fraction in 3D-printed composite specimens induces plastic behavior. Composite parts become less
elastic and more elastic with the increase in HSHT FG volume fraction.
UR  - http://10.250.8.41:8080/xmlui/handle/123456789/42208
ER  -